Skip to Content
استوری‌های سایت (فقط در حالت ویرایش دیده می‌شود): عکس را عوض کنید، روی عکس لینک بگذارید، متن زیر عکس نام استوری است. ستون‌ها را می‌توانید کپی، جابه‌جا یا حذف کنید.

When Should You Replace Your Brake Pads?

سه‌شنبه 19 آبان 1405 11:17:49 by
When Should You Replace Your Brake Pads?
CATO AI SERVICE
| No comments yet

Short answer: replace your brake pads when the friction material is down to about 3 mm, when you hear a constant squeal or a metal-on-metal grinding noise, when the car takes longer to stop, or when the brake pad warning light comes on. Mileage is only a rough guide: front pads typically last somewhere between 20,000 and 40,000 km and rear pads between 40,000 and 70,000 km, but your driving style and routes can change that a lot.

Why brake pad timing matters

Every time you press the brake pedal, the pads clamp the disc (or the brake shoes push against the drum) and turn your car's movement into heat through friction. That friction slowly wears the pad away. Brake pads rarely fail all at once; the system usually warns you first with noise, vibration or a change in how the pedal feels. Acting on those warnings early keeps your stopping power and protects the discs; a worn-out pad can score the disc and multiply the repair bill.

Signs your brake pads need replacing

1. Squealing or whistling when braking

Many pads have a small metal wear indicator. When the friction material gets close to its minimum, this tab touches the disc and makes a sharp, continuous squeal. A short squeak on a damp morning is usually just moisture; a squeal on almost every stop means it is time to check.

2. Metal-on-metal grinding

A harsh, growling or grinding noise usually means the friction layer is gone and the metal backing plate is rubbing directly on the disc. Braking is weaker and the disc is being damaged with every stop. Replace the pads as soon as possible and keep driving to a minimum until you do.

3. Longer stopping distances or a soft pedal

If the car takes longer to stop, or you have to press harder than before, the pads may be thin or glazed. A spongy or sinking pedal can also mean a fluid leak, so have the whole system checked.

4. Vibration in the pedal or steering wheel

Vibration while braking, especially from higher speeds, most often comes from a warped or unevenly worn disc. Pads and discs are usually inspected together. On cars with ABS, a pulsing pedal during an emergency stop is normal.

5. The car pulls to one side

If the car veers left or right when you brake, the braking force on the two sides of an axle is not equal. Usual causes are uneven pad wear, an oily pad or a sticking caliper.

6. Brake pad warning light

Some cars have a pad wear sensor that turns on a warning light on the dashboard when the pad reaches its limit. Other brake lights can mean low fluid or an applied handbrake; check your manual.

Typical brake pad life: front vs rear

There is no single number that fits every car. As a typical range, front pads last about 20,000 to 40,000 km and rear pads about 40,000 to 70,000 km. Front pads wear faster because most of the car's weight shifts forward under braking; on front-wheel-drive cars such as the Peugeot 206, Pride and Tiba, the engine and gearbox add even more weight to the front axle.

These ranges are rules of thumb, not a guarantee for any pad. Stop-and-go city traffic, mountain roads, heavy loads and hard braking shorten pad life, while smooth motorway driving extends it. The thickness of the pad is always the real deciding factor.

How to check your brake pads

  1. Look through the wheel. Turn the steering fully and use a torch to see the outer front pad through the spokes.
  2. Judge the thickness. If the friction material looks thinner than about 3 mm, plan to replace the pads soon. The inner pad can wear faster and is only visible with the wheel off.
  3. Check the brake fluid level. The level in the reservoir drops slowly as the pads wear. A very low level can mean worn pads or a leak.
  4. Have rear drum brakes inspected at each service. A handbrake lever that has to be pulled much higher than before is a common sign the rear shoes are worn or need adjusting.

It is a good idea to have pad thickness checked at every routine service, roughly every 5,000 to 10,000 km, and more often if you drive mostly in heavy traffic.

Find the right CATO brake pads

CATO manufactures front and rear brake pads and brake shoes for a wide range of Iranian and foreign cars, and each product page lists the code, axle and compatible cars. Popular pages include Tiba 1 and 2 brake pads, Pride brake pads, Peugeot 206 brake pads and Tara brake pads. You can browse every model in the CATO brake pad shop, and if you are not sure which code fits your car, contact us before you order.

Frequently asked questions

How many kilometres do brake pads last?

Typically about 20,000 to 40,000 km for front pads and 40,000 to 70,000 km for rear pads, but driving style, traffic and vehicle weight make a big difference. Check the pad thickness rather than relying on mileage alone.

What is the minimum safe brake pad thickness?

Most mechanics recommend replacing pads when the friction material is down to about 3 mm. Below that, braking performance drops and the backing plate can soon reach the disc.

Do I need to replace front and rear pads at the same time?

No. Front and rear pads wear at different rates and are replaced when each reaches its limit. However, the pads on the left and right wheels of the same axle should always be replaced together.

Can I keep driving with squealing brakes?

If the squeal comes from the wear indicator, the pads still have a little life left, but you should replace them within days. If the noise is a harsh metallic grind, the pads are worn out and driving on them damages the discs and reduces braking.

دیدگاه خود را بنویسید
نظرها پس از تأیید منتشر می‌شوند.
لنت ترمز داغ میشه؟ علت و راه حل